K1EL Systems LLC
Solder by touching your soldering iron tip to the pad to heat it up then apply solder to the hole in the pad and the solder will wick into the hole and make a good electrical connection. When complete, your work should look like the picture below.

Keyer Kits



PIC Tools





Contact Us
Frequently Asked Questions
Privacy Policy
About Us

Customer Service

Terms and Conditions
Return & Repair Policy
Ordering Info
Shipping Methods

Copyright 2000-2020 - K1EL Systems LLC
Twitter: @k1elsystems
News: K1EL Systems Blog
Help: K1EL on Groups.io

MTB Power Switch Installation
We have not been able to buy the original switches we used in the first kitting. Some kits will be shipped with switches that have a shorter lead length. They are still easy to install if you follow these suggestions.

You may have to bend/adjust the leads to get the switch to fit in the PC board. Since the leads are not long enough to go all the way through the board, we can't bend the leads over to hold them in place. Instead, tape the switch in place with a piece of tape on top of the board.